AWM-BT monitor mounts for ultrawide displays installation guide

The AWMS-2-BT75 Installation Guide PDFs are the official product setup reference developed by Atdec R&D. There is a version for grommet or F-clamp, each including a component checklist, important information, and pictograms for each step.

BT solutions installation video highlights

measure monitor mounting height for awms-2-bt75
Attach your clamp to the post and secure it to the desk as per the instruction manual. Clamp, grommet, and bolt through fixings each have an installation guide.
Glide the bracket onto the post, with the inside guide slotting neatly into the rear channel of the post. If the bracket guide is correctly inserted to the rear post channel, it feels secure and not loose around the post.
Do not move awms-2-bt75 with monitors attached
Adjust awms-2-bt75 bracket heights without monitors attached
Measure your monitor height and position the bracket at a comfortable position on the post to provide your monitor clearance above the desk.
Some ultrawide monitors require a VESA adaptor, which is typically included with the monitor. Consult your monitor’s instruction manual for details.

Your Atdec bracket comes with spacers and longer screws for monitors with recessed VESA surfaces, and shorter screws for those with flat or protruding VESA surfaces.
Mount two displays with flush bevel on awms-2-bt75
Extra space needed between tilted monitors on awms-2-bt75
It is recommended that you get assistance from another person to lift your monitor and slide the VESA adaptor into the saddle. After hanging your monitor, push the two side tabs in.
Movement of the display is expected if a load is applied to the corner. You should avoid putting a load on the corners of your display/s.
Avoid downward force on monitor corners
Extra space needed between tilted monitors on awms-2-bt75
The tilt knobs on the left side of the bracket (when looked at from rear) are used to loosen the tilt mechanism. If the tilt knobs do not loosen sufficiently for your monitor to tilt, the tension is set too high. Use the hex key provided with your bracket to loosen the tensions screws shown in this image. Loosen top and bottom screws a quarter turn at a time, clockwise, until you achieve the desired tension. Then position your monitor and tighten only the tilt knobs.

The reverse can be done if your tilt mechanism needs more tension.
If mounting a second display, ensure the top bracket is positioned with enough space for the top monitor to clear the lower monitor. We recommend you plan for 12mm or ½” gap.
Avoid downward force on monitor corners
Extra space needed between tilted monitors on awms-2-bt75
Use the fine tune adjustment knobs to ensure your monitor is level and to close the gap with two-monitor setups.

Long service life & 10-year warranty

Atdec products are designed for long service life – generally longer than monitors. So, it is likely that you will put multiple monitors and setups on your mount. Please reread the Installation Guide before adjusting or changing your monitors, and keep these key points top of mind.

different sized monitors are okay for awms-2-bt75
Different sized monitors are okay
  • Top and bottom monitors can be different size & model
  • Adjust tilt to compensate for varied monitor depths
  • Larger monitor in lower position promotes stability (recommended)
Always remove your monitors before moving awms-2-bt75
A two-person job
  • Get help to attach and remove monitor/s
  • Don’t risk your expensive ultrawide display/s
always remove monitors before main height adjustment of awms-2-bt75
Remove monitor to adjust bracket
  • Remove monitor before loosening bracket with hand knob
  • (Fine-tune adjustment knobs and tilt knobs are designed to use with display attached to bracket/mount)

Questions? Let us help.

 

Call us

8.30am to 5pm, Australia EST +61 2 8729 5000
 

Send an email

We will respond quickly Send an email